Make sure you have ntfs-3g installed sudo apt-get update Make sure you press enter after pasting this line or you will get an error on boot Mount NTFS Drive on Debian Make this network drive automount on bootįire up WInSCP, browse to and open /etc/fstab and add the following line making sure the uid and gid matches the output of id -u //networkip/share /local/linux/foldermountpoint cifs defaults,uid=1000,gid=1000,username=usernameonwindows,password=passwordonwindows 0 0 Now we mount the network drive, remember your network drives are case sensitive mount -t cifs //networkip/share /local/linux/folder -o username=usernameonwindowsmachine,password=passwordforwindowsmachine If you did not get an error all is well try and list the folder’s contents ls #How to configure sonarr pointed to a network drive update Mount the drive, sdc1 should be replaced with the sdx you found when you plugged in the drive sudo mount -t ntfs-3g /dev/sdc1 /place/to/mountįire up WinSCP, browse to and open /etc/fstab and add the following line /dev/sdc1 /place/to/mount ntfs-3g rw,uid=1000,gid=1000,dmask=0002,fmask=0003 0 0 sdc 3:0:0:0: No Caching mode page foundĪt this point it is safe to assume that the drive is sdc1 (but see below)Ĭreate a mount point to act as a symbolic link for the drive mkdir -p /place/to/mountĬhange the ownership of the mount path sudo chown -R user: user /place/to/mount Plug in the usb drive and you will see some messages on the debian box sdc 3:0:0:0: Assuming drive cache: write through Now determine the sda path of the usb drive. If on reboot the drive fails to mount it may be because linux assigned it a different letter when it was plugged in.
#How to configure sonarr pointed to a network drive password.#How to configure sonarr pointed to a network drive update.
#Ntfs 3g network share install#
0 kommentar(er)
